Dewatering Submersible Pump

SB introduces DEW series in Dewatering Submersible compact design pump below the motor It is Bottom suction Pump to pump out last level of water , there is common shaft between pump and motor, the pump motor unit is a close couple constructed and the double casing design provides effective cooling to the motor by water flowing around the motor casing, a perfect isolation is achieved with the help of a double mechanical seal provided in separate oil chamber and specially designed LEAP seal is fitted which keep motor away from the liquid being pumped, High grade corrosion resistance & abrasion resistance material is used.

Motor are winded with superior quality copper dual coated insulation class F with higher thermal class , centralized both Rotor & Stator are Impregnated with superior grade vanish under vacuum to avoid air packets, The winding are equipped with Thermal Overload Protection to protect against overheating of stator. insulation and designed for Higher efficiency followed by IEC standard.



Pump Type

Electrical Submersible.
Three Phase 380 to 550V.
RPM 3000 - 50Hz.

Class IP 68.
Maximum Submergence -10 Mtr(H2O).
Maximum Temp. 45 Deg.
PH Value - 5 - 8.
Operation - Vertical/Angular.
Impeller Type - Non - Clog Impellers.
Double Mechanical Seal.
Standard Cable Length - 10Mtr.
Dewatering mines, Pits, sumps etc.
Constructions sites.
Dams sites.
Cement/steel /paper industries.
Ash mixed water.
Turbid water.
Flood water pumping.
Drainage /sewage installation.
Material of Construction
Impeller - CA15(SS 410) Hardned.
Rotor Shaft - SS 410.
Mechanical Seal - Sic vs Sic.(Double).
Outer Casing - SS.
Stator Body - SS.
Ball Bearing - Radial/Angular.
Rubber Parts - Nitrile.
Contact Person:
Bhupinder Sarowa (Managing Partner)
Mobile: +91 9425156950
SB Pump
Plot No.30, Industrial Area Richhai, Jabalpur (M.P.)
Phone: +91-761-2330221, +91-761-2331485